Bushwalking Equipment | Keep Your Camera Working in the Cold and Wet

Ever tried to take photos in the rain on a cold day or come inside from the cold to a nice warm hut/car/tent and wondered why you couldn't see through the lens? Worried about what will happen when you go outside into the cold and wet?

These are universal problems for outdoors photographers and can be incredibly frustrating, as I recently experienced on the Routeburn Track in New Zealand.

Fortunately the cold itself is not usually a problem for a warm camera ( NB the same applies to your smart phone's inbuilt camera), as condensation does not form on warm objects and cold air is usually relatively dry. There are of course the dual problems of the rain or snow falling on the lens or getting into the camera electronics and then there are the  batteries, which often fail when cold. No batteries, no photos!

Solving the battery problem is relatively easy. Just keep the camera warm, next to your body, along with a spare set of batteries which you can use to replace the non-functioning cold batteries if needed. Swap them back with the newly warmed batteries, if you need to repeat the process. While they are much more expensive, Lithium batteries last longer and perform better in the cold than NiCad.

The difficulty of shooting photos in the cold and wet is that you often get water on the lens or viewfinder, which either makes it difficult to compose the shot or ruins it completely. Pull your rain jacket hood over your head and use a  peaked cap to keep the water off the lens and camera. Keep the camera inside your jacket near your body, where it's easy to find, not inside your cold backpack, where both the camera and the pack contents will get wet every time you want to take a photo.

The alternative of course, is not to take the camera out of you pack during rain, but then why bring your camera at all, if you're not going to use it. Wet weather photos are unique and mountain scenery with rain and snow falling, cascading waterfalls, racing creeks and swirling fog is magical.

If it's particularly cold and you are wearing gloves, then you have another problem. Take your gloves off and freeze while you operate the buttons or use a camera that is fully automatic. Even better, buy a waterproof fully automatic camera or a single use waterproof camera.

Coming inside after a long day in the cold is the most problematic. The greater the temperature difference between your camera and the warm moist air produced by all those wet clothes drying in front of the fire, the greater will be the condensation on your lens and electronics. The solution of course is to minimise the temperature difference by either pre-warming your camera or slowly letting it warm in the coldest place you can find inside.

Placing your camera in a waterproof bag before you come inside, will make sure that any condensation is on the outside of the bag not on your camera. Then its just a matter of waiting until your camera warms up before you take it out of its bag.

The same applies to your camera card and batteries, let them warm up next to your body before changing them in your camera.

Acknowlegement

Thanks to Bill S from Trailspace and the New York Institute of Photography for the inspiration to write this article. I needed reminding that condensation only occurs on cold surfaces.

Read more
Related posts
How to Use Your Camera in Cold Weather (RitzCamera.com)
Cold Weather Photography (Trailspace)


  This article by Bush Walker is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License.